What the Error Code Means
Error code E25 generally means the dishwasher detected a draining issue and stopped to prevent water from backing up.
It points to a drainage problem rather than a single confirmed part failure.
Common Symptoms You May Notice
- Water remains in the bottom of the dishwasher after a cycle.
- The cycle stops early or the drain pump runs longer than usual.
- The display shows E25 and the dishwasher does not complete the program.
Most Common Causes (From Least to Most Serious)
- Filter or sump area is blocked: Food debris can build up in the filter area and slow down draining.
- Drain hose is restricted: A visible kink or pinch in the hose can limit water flow to the sink or disposal.
- Drain system is not clearing as expected: In some cases the dishwasher pauses when it cannot move water out quickly enough.
Safe Things You Can Check Yourself
- Power cycle the dishwasher: turn it off at the control panel, wait a full minute, and turn it back on.
- Remove and rinse the dishwasher filter if it looks dirty, then reinstall it securely.
- Look for obvious kinks in the visible drain hose under the sink and straighten them if safe to do so.
If at any point this feels unsafe or unclear, stop and contact a professional.
When to Stop and Call for Service
- The E25 code returns after cleaning the filter and checking for visible hose issues.
- Water will not drain at all or keeps backing up into the tub.
- You notice leaks, electrical smells, or repeated shutdowns.
Typical Repair Cost Range
$150-$400 is typical for professional diagnosis and repair of dishwasher drainage issues, depending on the cause and parts involved.
Costs vary by region, model, and provider. Request an estimate before approving any repair.