What the Error Code Means
Error code 2 generally means the machine detected a flow or water-related issue and paused to protect itself.
It points to a condition the brewer wants you to address before it can continue safely.
Common Symptoms You May Notice
- The brew cycle stops shortly after starting.
- You hear the pump, but little or no coffee dispenses.
- The display shows error code 2.
Most Common Causes (From Least to Most Serious)
- Water flow is restricted: In many cases, a temporary blockage or buildup slows water movement through the brewer.
- Reservoir issue: If the water reservoir is low, not seated fully, or has an air gap, the brewer may pause.
- Brew path needs cleaning: Over time, residue can reduce flow and trigger a protective code.
Safe Things You Can Check Yourself
- Turn the brewer off, wait 30 seconds, and turn it back on to see if the code clears.
- Remove and re-seat the water reservoir, then refill it to the recommended level.
- Run a water-only brew cycle (no pod) to check if water flows normally.
If at any point this feels unsafe or unclear, stop and contact a professional.
When to Stop and Call for Service
- The error returns after a reset and basic water checks.
- No water dispenses at all or the machine shuts off repeatedly.
- You notice leaks, electrical smells, or unusual heat.
Typical Repair Cost Range
$80-$200 is typical for professional service or replacement guidance on small coffee makers, depending on model and warranty.
Costs vary by region, model, and provider. Request an estimate before approving any repair.